Just about all of my prints have these lines at around the same heights, and I can’t figure out why. I tried changing the nozzle, changing the layer height from 0.15 to 0.12, and changing the speed from 60mm to 40mm. All of these seemed to have helped a bit, yet they remain. I was thinking maybe as the prints get to a certain height, the shaking of the bed (Prusa MK2) caused the layers to be slightly offset perhaps. Anyone have any other ideas?

  • @rootOP
    link
    English
    211 months ago

    Thank you, checking this now. I made a change I found on a video and made a new post here.

    How did you relevel your gantry? From what I see, you can loosen the two things I pointed to in my new post.

    • @RustedSwitch
      link
      English
      211 months ago

      I have a different printer; it was a pretty involved process that required partial disassembly. I imagine this is very printer specific.

      • @rootOP
        link
        English
        111 months ago

        Gotcha, thank you!