A New York-bound Virgin Atlantic flight was canceled just moments before takeoff last week when an alarmed passenger said he spotted several screws missing from the plane’s wing.

    • @[email protected]
      link
      fedilink
      310 months ago

      Is there any advantage to those over square (Robertson)? I still see 4 contact points when applying torque. So about on par with square and inferior to 6-lobed torx.

      • @RubberElectrons
        link
        4
        edit-2
        10 months ago

        Well… It comes down to what material is used, as well as requirements and geometry for the screw.

        I love Robertson, but with enough over-torque, you shear the head off the threads or worse, round the hole if there isn’t enough rigid material around the square hole.

        Failure modes are: stretching the material outwards until the bit slips. For the torq-set, you would need to shear the screw head material in front of each of the driver’s tips off and out, much less likely than shearing the head off the threads, or shearing the bit itself.

        Both have the great feature that screws placed on the head stay in place, making installation much easier.

        Aerodynamically, the torq-set has a much smaller ‘opening’ than does Robertson or torx.

        Engineering is all about solving a problem in a quality way now, and ideally, considering issues for the future. A downside could be ice/grit getting stuck inside the smaller opening, as an example.