@PlutoniumAcid to 3DPrintingEnglish • 11 months agoLet's hear some fun ideas for confusing connector sleeves!i.imgur.comimagemessage-square200arrow-up11.59Karrow-down113
arrow-up11.58Karrow-down1imageLet's hear some fun ideas for confusing connector sleeves!i.imgur.com@PlutoniumAcid to 3DPrintingEnglish • 11 months agomessage-square200
minus-square@[email protected]linkfedilinkEnglish38•11 months agoThank you for pointing that out, I didn’t notice it lmao
minus-square@[email protected]linkfedilinkEnglish30•11 months ago(I think that was a joke, it IS actually a lightning cable)
minus-square@[email protected]linkfedilinkEnglish11•11 months agoYeah I’m not entirely sure, but it WOULD be possible to print a sticker like that
minus-square@[email protected]linkfedilinkEnglish7•11 months agoI know, I had to look at it for a while but the side edges in the pictures are rather sharp while a USB connector would have a completely round edge…
minus-square@jaybonelinkEnglish3•11 months agoThat reminds me of a joke about a dead baby and a blender.
Thank you for pointing that out, I didn’t notice it lmao
(I think that was a joke, it IS actually a lightning cable)
Yeah I’m not entirely sure, but it WOULD be possible to print a sticker like that
I know, I had to look at it for a while but the side edges in the pictures are rather sharp while a USB connector would have a completely round edge…
But which side would you put it on?
The outside
That reminds me of a joke about a dead baby and a blender.