Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

    • magnetosphere
      link
      fedilink
      29 months ago

      Because he’s my nephew. I care about him. He’s only in high school, he’s saving up for one, and I don’t want him to be disappointed/frustrated and waste his money on a crappy printer. If I can steer him away from bad printers and software, great!

      I also don’t want him to be discouraged. He’s smart, talented, and basically I want him to kick ass everything he does (I know that’s unrealistic, but hey, that’s the uncle in me talking). Plus, being good at 3D printing will be a valuable skill.