@Bartsbigbugbag to 3DPrintingEnglish • 2 years agoModelled and printed a piece for my fence. Has held up for 15mo and counting.imagemessage-square13arrow-up1152arrow-down12
arrow-up1150arrow-down1imageModelled and printed a piece for my fence. Has held up for 15mo and counting.@Bartsbigbugbag to 3DPrintingEnglish • 2 years agomessage-square13
minus-squareFartsWithAnAccentlinkEnglish2•2 years agolol, honestly I’d never even heard about ASA until you mentioned it. Is it easier than ABS?
minus-square@BartsbigbugbagOPlinkEnglish4•2 years agoIt’s not too bad. It does lift unless enclosed, but it’s basically ABS that’s slightly easier to print and UV resistant.
minus-squareFartsWithAnAccentlinkEnglish3•2 years agoSounds like a pretty good choice for this application!
lol, honestly I’d never even heard about ASA until you mentioned it. Is it easier than ABS?
It’s not too bad. It does lift unless enclosed, but it’s basically ABS that’s slightly easier to print and UV resistant.
Sounds like a pretty good choice for this application!