Louis Gray says he was racially profiled after trying to buy spray paint to make over his son’s bicycle helmet

  • @Paragone
    link
    5211 months ago

    Spray-paint tends to be solvent-based, and spraying it onto a helmet can fundamentally compromise its structure/strength.

    Please don’t ever use solvent-based stuff on multi-layer plastic helmets, for sake of your brain, who needs that helmet to work properly, when one gets slammed into the asphalt/concrete.

    Please.

    • That seems a bit unlikely. The solvents quickly evaporate off. Unless you are soaking it in solvents, there won’t be enough to cause any relevant effect. Meanwhile the helmet is exposed to UV light on a daily basis, which will also degrade it over time.

      You are also not going to burn from briefly touching laundry detergent, but keeping lots of it on your skin would be a problem.

      • @datelmd5sum
        link
        1411 months ago

        Helmets are usually polycarbonate and the common solvent in spray paint is xylene. Xylene causes extreme degradation in polycarbonate. If you don’t know if the helmet and the paint are compatible, it’s not safe to paint it.

      • @Hacksaw@lemmy.ca
        link
        fedilink
        -811 months ago

        Helmets are basically medium density styrofoam with a plastic cover. You ever spray painted styrofoam? It melts INSTANTLY …

          • @Hacksaw@lemmy.ca
            link
            fedilink
            2311 months ago

            I’m not here to tell you what to do but most regular consumer grade helmets I’ve seen would be hard to spray the outside without hitting the foam especially near the vents… Foam which, once again, melts INSTANTLY when spray painted. Foam which is also basically the whole protective value of the helmet.

            Anyways I’m sure there are helmets where it’s possible to spray paint without damaging the foam. Or you could do a good job taping. Or you could shrug at the hopefully minor foam damage. Many helmets never have to protect your head so you might be lucky there too. All I’m saying is that there are good reasons to say “don’t spray paint helmets” as general good advice.

              • WalrusDragonOnABike [they/them]
                link
                fedilink
                111 months ago

                Depends on how many vents and how small they are. At the very least, it could be very time consuming to avoid while also still spraying most of the hard plastic. Would be easier to hand-paint.

          • @Baahb
            link
            -611 months ago

            Is it even gray?

            “Too much water is bad for you.”

            True statement, like “spray paint will eat your Styrofoam”

            Misleading though cause no one is talking about spray painting sttyofoam

    • @ifGoingToCrashDont
      link
      1511 months ago

      That’s not how helmets work. The outer shell certainly helps mitigate bumps and bangs, but what really protects your head is the styrofoam inner that compresses like an airbag upon impact.

      • Neato
        link
        fedilink
        English
        3511 months ago

        No it’s both. The outer shell deforms before breaking and then the foam absorbs the rest of the impact.

        • @Hiccups2go
          link
          -511 months ago

          Dude there are many different helmet designs, with both thick and thin plastic covers. In a practical day to day use case, the plastic shell is there for appearance as well as protection for the primary means to prevent damage to the foam core of the helmet. The foam is no good if it gets damaged the first time you accidentally drop it on the pavement.

          I’m sure it can play some role in protecting your head, but it’s main purpose is to keep the foam on your head on one piece in case of an accident.