@lanolinoil to 3DPrintingEnglish • 9 months agoWell that's a new failureimagemessage-square19arrow-up155arrow-down11
arrow-up154arrow-down1imageWell that's a new failure@lanolinoil to 3DPrintingEnglish • 9 months agomessage-square19
minus-square@[email protected]linkfedilinkEnglish3•9 months agoAh OK, the thread on the nozzle just looked too short and a bit like it was broken at an angle.
Nope – right side is blob, left is nozzle
Ah OK, the thread on the nozzle just looked too short and a bit like it was broken at an angle.