Any suggestions before trying again after a reset? This is my first go round changing nozzle diameter. I went from a 0.4 mm nozzle to a 0.6 mm nozzle.

After the swap I checked my extrusion multiplier (no change needed) and tuned pressure advance (I had to decrease the value a bit, but it looks spot on now).

As part of the nozzle swap, I also bumped line width from 125% to 150% in Orca Slicer (should be around 0.9mm extrusion width) and increased layer height to 0.3mm. This should put me around 22 mm^3/s of material, which shouldn’t be an issue for a Rapido 2 but this is the most flow I’ve pushed through it so far. Maybe I should bump temp a touch? I’m still at my fairly-low-for-ASA 230 that I was using with my 0.4mm nozzle.

The print didn’t move on the bed and shows no signs of warpage. There also aren’t any signs of curling on the areas that the nozzle must have hit to cause the layer shift.

The only thing that seems like a miss was having z lift turned off while troubleshooting a print quality issue. I had it set to only lift above 0.25mm (not on the first layer) and only lift below z 0mm (this probably disabled z-hop). Z hop when retracting is set to 0.2mm, which is less than my 0.4mm retraction length so it seems like changing the “only lift below below z” value would re-enable z-hop.

  • @IMALlamaOPEnglish
    4•8 months ago

    @[email protected], replying to you as well here.

    This is a hardened steel nozzle. 260 looked a little rough, but 255 looks pretty good. The temp tower got knocked off the bed at 235. It does look like I’ll need to bump cooling a touch. Currently working on a retraction tower.

    If stringing is a problem consider increasing the speed of your filament retraction (not distance)

    I’ll have to give this a go after this retraction tower prints. On the last one I printed there was basically no difference on any of the settings once it got above 0.2mm of retraction. In my time with the rapido, any filament left in the nozzle will ooze out if its left hot but it doesn’t string that badly.

    You may also want to turn off z-hop. Sounds wild I know, but it does help- by not lifting the nozzle during a rapid move, it “wipes” the nozzle clean as it moves off the part and reduces stringing. Realistically you shouldn’t use z-hop at all unless you have a part with a very small cross section that keeps falling over when the nozzle wipes across it.

    Yup, I’ve run into this realization too - that’s part of the reason why I was thinking to have z-hop on for this print

    Which ofc, the big print I see in the photo looks like it will have zero stability problems, lol.

    Adding two more bed fans, for a total of 4 (2 loose bed fans, 2 fans in my filter) and getting a bang on first layer (yay klipper_z_calibration) seem to have really helped with warping. I do have some ACM panels that I want to swap on to bump chamber temps up more, but I haven’t taken the time to print new magnetic inserts for them yet.

    Knock on wood…

    • DettweilerEnglish
      4•8 months ago

      I’m definitely going to try the retraction speed (instead of distance) and no z-hop in the morning.