You must log in or register to comment.
Reminds me of a tip for a soldering gun.
Yup!
This is the correct answer.
I was just going to say that.
Some sort of specialty tweezers?
Edit: Nope.
With two separate parts of it while being connected, it makes me wonder if it is some sort of electric heated Cutter
You’re close! (But it was also solved 8 hours ago)
Weird. Mine is the only comment I see.
ty for reminding me to mark it
I haven’t seen a finger harp for awhile.
chopstick trainer?
No (and somebody else did get it) but I love that guess.
I’ve only ever seen plastic/rubber ones but thought there might be metal ones, heh.
It’s something that goes at the end of two sticks to pull something out at an angle, like the back of the hammer.
Edit: Wait. It’s not a tool head. Wouldn’t make sense. I’ll be back.
It’s the end of something that something else slides into. To screw the two screws into a surface, and then push a slide part into the slit, and the angle in the part holds stuff together?
Tip of a fountain pin?
No but again, love this answer.
Man I wish my wood burner came with an attachment like this. I use it to smooth certain parts of 3d prints, but the tips I got are all pretty small so it’s not good at smoothing large areas.
Harbor freight sells a plastic “welder” that is basically just a soldering iron/wood burner with a big flat tip, might be what you are looking for
Yeah I’ve seen a couple. Problem is I still can’t figure out exactly what temp I need to be at to melt the PLA without it burning or sticking to the melting tool. It seems to have such a specific temp where it all works but I am not able to replicate the same temp with the dial. I got a Lazer thermometer and the dial on wood engraver seems off by a good margin and not always in the same amount.
I gave up trying to keep plastic from sticking to the tool, instead I just wipe it on whatever junk mail I’ve received recently. Mine is set to about 220°C and I don’t have to clean it super frequently unless I’m adding gobs of plastic for a deeper weld. I should also mention I use a soldering station which I’ve found has more accuracy than any plastic welders I’ve tried. Downside to this is that the plastic kinda ruins the coating on the tip for actual soldering, but I get around this by just swapping to another tip.
Sounding rod
![[Challenge-Solved] more weird metal things lol](https://sh.itjust.works/pictrs/image/4a8757ab-0295-417f-a2dc-3a2a42f64152.png){kind=link}