This just happened for a second time… I’m running octoprint on a windows desktop computer that lives next to the printer (no raspberry pi for me yet).

Twice now, it has disconnected mid-print. The printer and PC are both online and physically connected. Disconnecting and reconnecting in octoprint works, and I have been manually checking the last gcode sent successfully in the terminal and copying the remaining code out of the file from there and printing that - it works but if it has been disconnected for a while before I notice, the spot where the extruder was sitting gets a little melty and there are some artifacts in the print.

Is there any octoprint plug in that can automate this process so I don’t have to manually edit the gcode? Or any tips on preventing disconnects?

I’m pretty new to this whole world of 3d printing and even newer to octoprint so I may be missing something obvious.

Thanks!

  • Augapfel
    link
    fedilink
    English
    51 year ago

    I had the same issue and I think it happened because of a cheap USB cable. It sometimes even disconnected when I touched the cable. So I switched back to printing from sd card.

    • @[email protected]OP
      link
      fedilink
      English
      21 year ago

      Yeah I will try switching cables and if it happens again I’m going back to SD cards. I really liked the convenience of it but that is not applicable if it keeps failing

  • @[email protected]
    link
    fedilink
    English
    41 year ago

    You need high quality USB cable, not too long and try not to guide it next to stepper motor or stepper motor cable. Just rerouting the cable might fix the problem

    • @[email protected]OP
      link
      fedilink
      English
      2
      edit-2
      1 year ago

      I didn’t think about interference. It is pretty close to the bed heating cable and the extruder cable. Probably touching those at points. I will probably stick with the SD card until I can get a Pi and use a much shorter cable. I just lost a print due to this happening 3 times and at this point I don’t want to risk it again right away

    • @[email protected]OP
      link
      fedilink
      English
      21 year ago

      Ahh that makes sense. Both times have been since I switched to a new cable. Guess I got a bad one. I’ll switch back to the one I had before.

  • LazaroFilm
    link
    English
    -31 year ago

    Why are you using Octoprint instead of Klipper?

    • @[email protected]OP
      link
      fedilink
      English
      31 year ago

      Octoprint is a software to manage a printer running marlin firmware.

      Klipper is a different printer firmware, and is not something you can use to manage a printer running marlin.

      I do want to look at flashing klipper to my sv06 someday but right now I’m just trying to print stuff without manually moving an SD card every time.

      • LazaroFilm
        link
        English
        11 year ago

        I used Octoprint for a few years before switching to Klipper. Octoprint was good but Klipper was like discovering that you can fly.

        • @[email protected]OP
          link
          fedilink
          English
          11 year ago

          Are you using mainsail to interface with the printer? That is what I have seen most people recommend for klipper printers

          • LazaroFilm
            link
            English
            2
            edit-2
            1 year ago

            Mainsail on my computer. KlipperScreen on my printers touchscreen. MobileRaker on iOS. I also use TelegramMoonraker to interact when away without opening ports. All managed via Moonraler (klipper’s API)