I ran a selftest and the manual test and the X-axis keeps failing. I don’t know why.

I tried:

Re-lubing

adjusting the X-axis belt

Adjusting the cables

I’ve had no luck with anything :/

Edit: I’ve watched a video and the extruder just hangs on the left side it for most the time it doesn’t go left then right, right aaway

Edit 2: I found the issue that I completely overlooked cuz I was annoyed…the bearing was sticking out somehow

  • @dirtdiggerEnglish
    4•7 months ago

    Prusa machines come with phenomenal support, why not consult them directly?

    • @chrischryseOPEnglish
      2•7 months ago

      Figured I’d make a post while I wait the 30 minutes

    • @chrischryseOPEnglish
      1•7 months ago

      Yup. And not sure if it matters either but x axis reads as 251

        • @chrischryseOPEnglish
          1•7 months ago

          I’m dumb, I found the issue…One of the bearings was sticking out Idk how I missed that especially looking stuff up ;-;

            • @chrischryseOPEnglish
              1•7 months ago

              Np lol. I honestly didn’t expect it, like it’s screwed down so how could it move? I love troubleshooting soooooo much

  • Thanks4NothingEnglish
    1•7 months ago

    Was it a kit? Had it been printing before you started getting this issue or was this an issue out of the box?