I want to mount a printed part to a standard 2mm motor axis which doesn’t have any dents or profile. Its just round. If I print at exactly 2mm, it fits for the first few times until it gets too lose and the spinning part sometimes falls off.
I want to mount a printed part to a standard 2mm motor axis which doesn’t have any dents or profile. Its just round. If I print at exactly 2mm, it fits for the first few times until it gets too lose and the spinning part sometimes falls off.
I will be using PLA
For production parts look at other materials. Nylon might still be within the range of your 3D-printer.
For attaching: If you can’t clamp then look at gluing it in place. If you need it detachable maybe drill a hole in the shaft and use a R-clip.
You can also tap and die the shaft on top. Make sure to use a left or right-handed thread depending on the rotation/load (thread is so that the rotation/force isn’t unscrewing it).