A few of you may remember my post about the back end of my boat falling off and wanted to say thank you for all of your advice/encouragement!

I started building a new rudder a couple weeks ago and am probably a couple weeks out from getting it finished up. The hole in the back end has been sealed up and I built a much stronger mounting point than the original system.

I found a template of my boats rudder and modeled a copy then 3d printed the core. Between the fiberglass and the rods I’ve added for rigidity, I’m hoping it works out well. It may be coming up to October, but I think I’ll get at least one test run before the season ends.

  • @[email protected]
    link
    fedilink
    English
    23 months ago

    I built a replacement part for a boat, but used pkywood and Gflex…and lots of sanding.

    • @Koopa_KhanOP
      link
      English
      13 months ago

      I’m about to start the sanding process. I did a bit by hand before deciding to pick up a sanding tool this week. Fingers crossed that makes the fiberglass sanding easier as well