• Captain Aggravated
    link
    fedilink
    -21 year ago

    I’ll tell you something I do as a woodworker a lot that metric isn’t great for: divide by powers of two, three or four. I’ve got some boards milled up 3/4" thick. I’m going to join them with a bridle joint, that means cutting the middle third out of one and the outer two thirds from the other. So each of the remaining “tongues” are each 1/4" thick. 3/4" is approximately 20mm. That’s a nice metric number, a multiple of 10. Let’s cut that same bridle joint in 20mm stock. What’s a third of 20mm? Can you come point to 6.6666mm on my metric tape measure here?

    Don’t pretend base ten doesn’t do stupid things too.

    • @[email protected]
      link
      fedilink
      6
      edit-2
      1 year ago

      Can you come point to 6.6666mm on my metric tape measure here?

      Yes: For woodworkers, it’s identical to 6.5mm, accurately eyeballed at between 6 and 5mm. Don’t pretend you’re a machinist. Does your tape measure even have a vernier scale. Does it make satisfying clicks when measuring. If you have a slip instead of interference fit just dump one piece in water for a second it’ll be fine.

      • @angrystego
        link
        11 year ago

        To be more precise, it should be rounded as 6.7 cm, accurately eyeballed at between 6.6 cm and 6.7 cm.