Tesla is facing issues with the bare metal construction of the Cybertruck, which Elon Musk warned was as tricky to do as making Lego bricks

  • @curiousPJ
    link
    English
    2
    edit-2
    1 year ago

    Bilateral tolerancing is a Machinist’s first introduction to tolerancing so it’s no surprise to run that as default. And I suppose GD&T is not heavily used where you are.

    If you’re given a parallelism tolerance of 10 micron are you assuming that to be ±10 micron? True position? Angularity of 5 thou? Etc… The only feature control that could be interpreted as bilateral by default is profile and it’s still communicated by its total tolerance.

    Simple ± tolerancing isn’t the industry standard anymore. And if Tesla prints are anything like spaceX ones… It’s basically all GD&T and minimal title block tolerances.

    • @[email protected]
      link
      fedilink
      English
      11 year ago

      I use GD&T on all my drawings, including 100% of my hole callouts. However I’m one of the more enthusiastic adopters of ASME Y14.5 at the place I work. Therefore, I get what your saying regarding the tolerance range, but since most of my coworkers are still relying on block tolerances, I’ll refer to a .010" positional tolerance as a “+/- .005” equivalent" in conversation so there is no miscommunication. I can see how this is not the norm.