@Giu176 to 3DPrintingEnglish • 10 months agoTasteful biscuitsimagemessage-square13arrow-up1225arrow-down17
arrow-up1218arrow-down1imageTasteful biscuits@Giu176 to 3DPrintingEnglish • 10 months agomessage-square13
minus-squaredual_sport_dork 🐧🗡️linkEnglish15•10 months agoRockin’. INB4 you get crucified for FDM prints not being “food safe.” …I might just be having flashbacks to that time spent at the other place, though.
minus-squareThe PantserlinkEnglish11•10 months agoI use fdm prints for food all the time. Just use once and throw away. As long as you use steel nozzle I think it’s fine no lead dangers.
minus-square@brenticuslinkEnglish7•10 months agoYep, not usually safe to reuse your prints or put them in heat or get them wet, but for a single batch of cookies the risk of a 3d printed cookie cutter is pretty minimal.
minus-square@ZagamTheVilelinkEnglish10•10 months agoMy wife did me a favor and soaked all my pla cookie cutters in super hot water to get them clean.
minus-square@[email protected]linkfedilinkEnglish4•10 months agoI print with PETG and run them through the dishwasher.
minus-squarethreelonmusketeerslinkfedilinkEnglish4•10 months agoIf I vapour smooth it with acetone, would be safe then?
Rockin’.
INB4 you get crucified for FDM prints not being “food safe.” …I might just be having flashbacks to that time spent at the other place, though.
I use fdm prints for food all the time. Just use once and throw away. As long as you use steel nozzle I think it’s fine no lead dangers.
Yep, not usually safe to reuse your prints or put them in heat or get them wet, but for a single batch of cookies the risk of a 3d printed cookie cutter is pretty minimal.
My wife did me a favor and soaked all my pla cookie cutters in super hot water to get them clean.
I print with PETG and run them through the dishwasher.
If I vapour smooth it with acetone, would be safe then?