Germany is struggling to get people on-board with a green energy movement that involves banning high footprint domestic heating systems (e.g. gas boilers)-- thus forcing people to migrate to heat pumps. A low-income family who was interviewed said it would cost €45k to install a heat pump in their terraced home in Bremen.

That price tag sounds unreal. I am baffled. What’s going on here? I guess I would assume an old terraced German home would likely have wall radiators that circulate hot water. Is the problem that a heat pump can’t generate enough heat to bring water to ~60°C, which would then force them to add a forced-air ducting infrastructure? Any guesses?

(note the link goes to a BBC program that looks unrelated, but at the end of the show they switch to this issue in Germany. I’m not sure if that show is accessible… I see no download link but that could be a browser issue)

  • @TBi
    link
    46 months ago

    I agree with you. But there are breathable insulation types for these older houses. So they can be used. These are more expensive so should have higher tax breaks when applied to houses that need them.

    Also I agree with the wearing extra clothing part. One extra jumper never hurt anyone.

    • Hyperreality
      link
      fedilink
      5
      edit-2
      6 months ago

      You are basically correct.

      But allow me to rant, for which I apologise. Feel free to ignore, it’s not that interesting, and I’m not an expert.

      The main thing is (properly installed) moisture barriers, if necessary increasing ventilation, getting rid of any moisture, choosing the right insulation for the right job, etc.

      Eg. rockwool is very absorbant and is even used in hydroponics, but if you pop it in an attic, use a decent moisture barrier, but ventilate it well, it’s not a disaster if it gets a bit moist sometimes. Meanwhile, in an (almost always) damp basement, forget using rockwool. Even using PUR/PIR foam is likely to cause issues, even if you use the best and most professionally installed moisture barrier. Better off using XPS. Meanwhile, when it comes to wall insulation in older houses, spraying foam into the intrawall cavity(inner wall, space, outerwall), can also cause issues.

      The problem is that people will hire a company with a load of good reviews. They’re friendly, they’re affordable, afterwards the house is nice and warm and well insulated. Everything’s covered up, so even if you were an expert, it’s not as if you can check if they didn’t half arse their job or if they aren’t well intentioned morons who installed a moisture barrier the wrong way around so it only allows moisture in rather than letting it out… But years later, when the damage starts becoming apparent, when people start falling ill from mould, or the concrete has become so weak so you have a pothole in your living room, the company likely doesn’t exist anymore. And it’s not as if you can hire a company with 50 years experience, because some of these kinds of insulation are quite new, and not everyone has experience working with older houses.

      Eg. Lime mortar started being being phased out at the beginning of the 20th century, so it’s no surprise someone who’s ‘only’ 40 wouldn’t know it has different properties than portland cement.

      And for professionals who do know their shit, do it properly, and charge accordingly, it’s not unlikely the homeowner will go with the cheaper offer because they don’t think it’ll make a big difference but can save thousands.

      • @TBi
        link
        36 months ago

        Good read and good points. Thanks for sharing/ranting!