• FartsWithAnAccent
    link
    English
    92 years ago

    It’s gonna melt any day now because you didn’t use glass filled nylon!

    • @BartsbigbugbagOP
      link
      English
      52 years ago

      Haha. I was a bit concerned about it, so I used ASA, and it seems to be holding up alright. Fingers crossed it continues to do so.

      • FartsWithAnAccent
        link
        English
        22 years ago

        lol, honestly I’d never even heard about ASA until you mentioned it. Is it easier than ABS?

        • @BartsbigbugbagOP
          link
          English
          42 years ago

          It’s not too bad. It does lift unless enclosed, but it’s basically ABS that’s slightly easier to print and UV resistant.

          • FartsWithAnAccent
            link
            English
            32 years ago

            Sounds like a pretty good choice for this application!