Been a few months of on/off designing and printing, but it’s on four wheels now (the correct offside rear is being printed right now) still loads to do, the temporary diff is too low, leading to the axles falling out and the tyco bandit inspired body is no where near fitting yet.

  • @tpihkal
    link
    28 hours ago

    What modeling software are you using?

      • @tpihkal
        link
        17 hours ago

        Inventor is as powerful parametric modeling software that you really need!

  • @papalonian
    link
    28 hours ago

    You designed the whole model? That’s sick!

    • @[email protected]OP
      link
      fedilink
      18 hours ago

      Thanks, the chassis is all mine, except the diff, which I know won’t last but just haven’t had the time to design a replacement yet. the body was one I picked off of thangs and slightly modded. I’ll credit the creator when I get around to releasing it.