As someone whose job is drafting and whose being is overly-perfectionist I hate them and hope they bump their head hard enough to knock some damn sense into that empty cavity.
I mean, Like, if you were to guestimate based on where the top dimension line is… I’d say that’s at least two, three inches from the end on either side.
And yeah, it being an inside or outside measure might be important. There’s somethings you should be rather OCD about, and I’m still impressed with the fabricator adding that to the top and sides. Cheeky bastard.
As someone whose job is drafting and whose being is overly-perfectionist I hate them and hope they bump their head hard enough to knock some damn sense into that empty cavity.
I mean, Like, if you were to guestimate based on where the top dimension line is… I’d say that’s at least two, three inches from the end on either side.
And yeah, it being an inside or outside measure might be important. There’s somethings you should be rather OCD about, and I’m still impressed with the fabricator adding that to the top and sides. Cheeky bastard.