• @roofuskit
    link
    English
    129 months ago

    Hmmm, huge burnt up glob of filament that was stuck to the nozzle, came off, cooled and then caused a layer shift?

    Just a guess from what I can see.

  • @Dagamant
    link
    English
    9
    edit-2
    9 months ago

    What is that a bug?… Oh…. The nozzle… Yeah, that’s a new one

    • @remotelove@lemmy.ca
      link
      fedilink
      English
      1
      edit-2
      9 months ago

      Just playing a guessing game here…

      The nozzle was probably already loose, for starters. It may have been possible for the nozzle to catch on the print with a blob that was forming from the loose nozzle.

      Once the nozzle was stuck to the print, it got ripped off the bed and the movement of the gantry likely caused the print to spin. If a “leg” kept getting caught on something during travel, that would make sense.

      After a few dozen moves, presto! Nozzle is unscrewed and is now one with the print.

      Unless something in the hotend was actually broken to cause this, it’s a perfect example of why nozzles should be tightened at a higher than normal temperature. Loose nozzle == bad time.

  • @Voyajer
    link
    English
    39 months ago

    Did you perhaps forget to hot tighten the nozzle? That’s a crazy failure to have.

    • @lanolinoilOP
      link
      English
      39 months ago

      I had just put it on hot earlier that day. I must not have tightened it fully I don’t have any other explanation.

    • @lanolinoilOP
      link
      English
      29 months ago

      Nope – right side is blob, left is nozzle