This is a battery cell case that was a pain last time I printed it with supports
You must log in or register to comment.
As a total beginner, it’s not really clear to me what’s meant here. I read printing some things are better to print at an angle, like boxes, for additional strength. Is that what’s meant here?
What exactly is the difference to just printing it standing?
Less overhangs?
That’s so smart! Thanks for the tip
That’s actually genius, thanks for the tip man
Ohh nice, battery pez dispenser!
Is that considered a raft + supports or just supports on there?
Just supports, I had to manually paint them in to prevent the slicer from putting them all the way up the side
In Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.
Looks like the model is just resting on supports. Might have a roof or “support interface” (a layer between supports and model)