I recently switched from wireless to wired headphones (Samson SR-850, probably the best for the very reasonable price) and my chair’s wheels instantly started eating its cable. Right now I’m using a small plastic hook that came with a face mask to keep it off the floor, but I’d like to hear other solutions.
Poorly
The only right answer
I run the cable on top of my desk instead of under. Makes the desk look more cluttered, but no risk of catching the cable in the wheels.
This is what I do. My headphone amp is on my desk, so it just worked.
I wish that worked for me. The armrest of my chair catches onto every bit of cable it finds slightly hanging off the table. Granted, that’s only an issue because the armrest is T-shaped rather than O-shaped.
Do you want cats on your desk? Cause that’s how you get cats on your desk.
I have these things all over on the underside of my desk.
https://www.amazon.com/dp/B01LYO307S
It’s also how I keep the end of my phone charger always within reach.
This is the winner, I’LL TAKE YOUR ENTIRE STOCK!
Haha, glad I could help. I love these little things.
Link already died?
Still works as far as I can tell.
Ah, indeed. No idea why it didn’t work yesterday.
I have a hook on the cabinet next to my desk that I hang my headphones on when not in use, but that the cable is also attached to. This keeps it out of the way. So the cable is basically hanging between the cabinet and my head. The cable also separates in the middle, so it tears away if I accidentally get up and walk away with them on.
I do the same. I have a few different headsets so it’s nice to have somewhere to put them.
There’s very cheap cable holders for VR applications that attach to your wall or ceiling (non-destructively) and hold cables above you. I used those above my desk to hold the headphone cables, so the cable runs up the wall behind my desk, and then over my head. Keeps it off the floor and away from everything else.
I used a coiled cable and put my audio interface to my side higher up on a shelf. That way when I am seated the headphone cable barely touched the ground.
Shorter cables are probably the best solution.
deleted by creator
I made my own anchor points with some mason line, a broken DVD case and double sided tape been going on for 4 years now. Think there’s adhesive cable clips too that comes with several for cheap so you don’t have to go through my dumb idea just prepare the area by cleaning it with alcohol first
Roll up the excess cable into a loop and sellotape the loop to stay in a loop. Maybe looks ugly but nobody else sees it lol.
usually no
NZXT Puck. I have 2 which means I have 4 cable holders.
I have a pair of Philips Fidelio X2HR, they are connected to my Röde VideoMic Go II so I use my mic as a soundcard when gaming with friends.
My mic is mounted on a microphone arm, and the cables are routed along the arm, unfortunately my X2HR has a VERY long cable, but it commes with a wire clamp thing so I have simply collected the exessive cable into a loop with the clamp and let it hang down from the arm but never low enough for me to roll over the cable with my chair.
If you don’t have a clamp, I would recommend some steel wire to make a sort of clamp to organize the cable.
I drilled long screws in a shelve, wrapped it with thick paper and ducttape. Works like a charm.
I got this thing called the J22 that I can plug my wired headphones in and put it my pocket or clip to my shirt that then connects via Bluetooth. No more issues with getting wires caught to stuff and no lag.
